Search results

Hi - can anyone assist with this issue? I am looking for the pinout diagram for the large white connector in the below pic - its on a VY 5.7 LS1 auto harness. This section looks like it is fitted on the inside of the firewall. There are 2 plugs - the large white plug and the smaller black...

Hi all, looking for some advice about an engine/trans swap I am doing to an XJ6 Series 3 Jaguar. The engine is a VY LS1. Trans is a 4L60E. I have just purchased a complete VY ECU/wiring harness combo, to fit the LS1. The issue is simply this - the VY auto harness has the big rectangular grey...

please ignore, posted question in the wrong area.

after sorting out the issues with the fuel pump in the S1.......there was a smell of petrol wafting about when I pulled into the driveway yesterday. Thought it could have been a bit of a weep from the fuel pump gasket.......so reversed up onto the car ramps to have a look underneath. FMD...

Hi - have had a look at the threads on fuel pumps for the Series 1 - didn't find the answer I was looking for....... Had a fuel pump die last week - no probs, picked up a Goss pump at Supercrap for $90. Installed on Friday morning........worked for 2 1/2 days - then failed on Sunday afternoon...

At the rear of the engine bay in a VN, almost directly under the bend of the air inlet pipe into the throttle body and located on the firewall - is a small vaccum line which comes off a T-piece ? It looks to me like the right-hand end of this vaccum line runs out to that emissions/pollution...

Hi all I have done a lot of digging through the forum looking for some specific info about swapping a 1991 S2 motor/auto, into a 1989 S1 body........found some good info but still need a couple of tips from anyone who has done this. Basically - the old S1 motor lunched a piston due to...

Just looking for some advice about replacing a tired old Series 1 VN V6 with a later model V6. From what I can see on the forum, it looks like the VS Ecotech Series III with the 4LO-E gearbox would be a good candidate ? Is this a straight swap or do I need to mix-n-match any engine/box...

Thanks to the tips from this site about how to check fault codes, and what they indicate, I have a Code 22 fault. So I took the TB off, and gave it a good clean with aerosol carbie cleaner. Took out the TPS, and it was really filthy - so gave it a good clean as well. This seemed to fix...

Hi - normally I cruise the VN-VP forums, but tonight I have some questions about the LS1 motor and transmission - hoping that someone here may have some answers.... In a nutshell - I want to fit one of these motors into a Series 3 XJ6 Jaguar....:whistling (please don't hate me....;)) - as a...

During a shed clean-out a couple of years ago - a mate of mine gave me a pair of front springs, reckoned they were lowered and would fit the VN. The only identifying tag on them says HF 12L, and what looks like a batch-number - 9303NB (March 1993 ??) They are red springs (assume old...

As promised, here are some early details of the LPG conversion done here on Wed/Thu this week; 1. Its an Italian system, Landirenzo; 2. System A/1 - VO5 (computer) 3. Set to change onto LPG once you (a) go over 2000rpm, and then (b)decelerate - it then automatically changes to LPG, and...

Hi all - Have a simple question on O2 sensor replacment - How the f$#k do you get a 7/8 ring spanner over the old sensor and undo the b@st@rd ?? I always get suspicious when the book says '....If access to the oxygen sensor cannot be gained, remove the exhaust manifold as decribed in the Engine...

Hi all - given the number of people with the same problem, I had a go at fixing this today, and it worked, so here is a quick rundown: The problem as pointed out in a previous thread is the 3-pin 5-volt voltage regulator on the circuit board inside the cluster - dry joints on the 3 pins. This...

Hi all Only new to this site, but have already learnt heaps about my old Series 1 VN Exec. Was real interested in the CAI threads, so fitted one on the weekend to see how it would go. The missus reckons the car feels better already, a bit more responsive off the mark etc. Anyway, part...