MasterOfReality
Miners go deeper
- Joined
- Feb 26, 2004
- Messages
- 875
- Reaction score
- 1,082
- Points
- 93
- Age
- 44
- Location
- All over
- Members Ride
- 2019 LC Sahara TTDV8, 1991 VP Calais V8
Hi guys.
Got a new T5 clutch fork and steel throw out bearing The pivot ball has been pre set at 105 mm and I’m going to install the clutch fork and bearing soon.
With the clutch cable off, should there be a gap between the throw out bearing and the pressure plate fingers?
Thanks!
Got a new T5 clutch fork and steel throw out bearing The pivot ball has been pre set at 105 mm and I’m going to install the clutch fork and bearing soon.
With the clutch cable off, should there be a gap between the throw out bearing and the pressure plate fingers?
Thanks!