manual commodore

I have installed my new Aerpro (FP9450BK Install Kit suit Holden Commodore VE Series 1 Dual Zone A/C Black) myself… Since installation headynit works fine but have lost all AC controls on facia kit. Not sure if I missed something because it doesn’t seem to be a fuse. And no air is coming out...

Can't seem to find a dip stick for the trans on my vx and don't know how else to check the fluid levels

Hey guys Might be a dumb question but I have a factory manual vs commodore executive and want to put a L67 motor in it I wanted to know will the m35 gearbox bolt straight up to the l67 motor or will I have to modify/ or will it not work. Thanks

Hey guys i’ve got a 03 vy ute v6 and i’ve been trying to skid it and it skids fine in 1st but when i change to 2nd the brakes go completely hard and i can’t keep the skid going. not sure if this is normal or not but just wondering if anyone has advice. cheers

Recently purchased a factory manual VX S pac. Unfortunately once again I have come across the dreaded ‘rev hang’ between gears. I’ve read through every thread in here and no one seems to have a confirmed ‘fix’. A lot of people dismiss the problem altogether blaming it on the dual mass...

Hi, I've got a 2007 VE SV6 and it won't start after an engine swap. I've been told it's most likely the bcm. Are these able to be reprogrammed/reset or do I need a new one?

Hi just wondering I have an unregistered manual sv6 Wondering how love can I go for springs to get a rwc and to be checked off by Vic roads is fe2 the lowest?

Recently done a VT motor conversion into a vs ute, runs and drives good at times but has a dead spot like a miss when you hold it to the floor. It seems to run a bit better once warmed up & it revs clean when it’s up in the higher rev range Done a list of things that haven’t fixed it, not sure...

So I have a 2003 vy commodore v6 3.8ltr now she's factory manual So my question is in finding with take off that it takes a good 2 - 3 secs to build up revs from zero and I was wondering if there was any a way to improve that building of rpm so I can get to 2nd quicker Should mention she's...