Recent content by Sam Barnes

Don’t know if I’m gonna be able get much help without providing the video but, I pulled out my front struts n put in another set n since then there’s a noise rubbing creaking noise everytime I turn the wheel. I’ve got no idea what it is or how to fix it so any help would be good n if there’s a...

I’ve got a couple more places to go to before I start looking at a normal mechanics but if I get no luck I’m probably going to have to.

I thought the same but I’ve gone to 5 performance places over this week n haven’t had any luck. The best reply I’ve gotten so far is that they need an apprentice but can’t hire one until they get another fully qualified mechanic.

After a job

Bit of a long shot. But does anyone know of a performance mechanic shop looking for an apprentice or just some help. On the Northside of Brisbane. I’m looking for a mechanic shop that focus more around performance upgrades and engine enhancements.

Don’t have anything showing up on dash. Got the abs n brake light but those were always there I’ve just not got round to fixing them. Only thing I’ve done recently is give scrub off all the grease in the engine bay to make it nice and clean

i got it running the other day I just tried turning it on n held the key at full lock and it started but the hole half hour plus it sounded weird and not right. I tried again today and it didn’t wanna start at all. Only got it to turn over an run for 2 seconds or so again

My v6 vx won’t run. It’ll turn over an fire up for a second or 2 then cut out. I’ve put new fuel in ,charged my battery and it still won’t run for more then second 2 seconds. What am I gonna have to try to get it running.

I grab a pic tomorrow it’s looking just flat currently. I think to get the correct shape I should of let it dented n bogged ontop of it cause like u said looks worse.

Meant to do that after replacing heater valve or just a good option to fix the issue?

Aload of smoke was coming from it when it started over heating before I replaced it why I was less to believe that was the issue

I’ve had an over heating issue which I was told was due to the heater valve being busted. I’ve just replaced it with a new one n I still seem to be overheating after 8 minutes of idling.

hey so on my vx s pac I had a dent just next to the fuel filler flap n I’m struggling to recreate the shape with bog I’ve pulled the dent out as much as I could before starting. Do I just need to put aload more bog on n slowly shape it or would there be an easier way

Way to fix it or just gotta replace?

3/4 full. I’ve got a pipe infront the radiator that’s rusted n is leaking it