Just bought a pair of K Sport coilovers for my VU ute. Was told that they came out of VZ Ute. The bottom shock fitting dosnt fit my VU. The tube that goes through the bottom shock rubber that fits into the trailing arm of the ute is too wide.
My question is, do VZ Ute rear shocks fit straight...
Na just the one strut. It's bent on the base of it right where the top of the mount is. All the rest of the gear is ok. Glad it's just a strut. Throw away item.
That ute I wrecked out had a knock in the front bumper, head light and a tiny bit of the top corner of the radiator support panel. I...
Bent strut. I can't believe I missed seeing it when I put them in from another ute I wrecked. Bent at the top of the stub axle mount on the base of the strut. Must have been a busy day the day I swapped them over.
Got pedders bushes up top and those still look pretty good. Bearings are still...
I'll have to get in there and see what's going on. Chances are they're stuffed. Got few other sets that I can chuck in in the mean time if the ones in there are dead.
I'm just trying to remember the ones I had in the SS. They were nolothane. I think they might've been adjustable, can't remember. Weren't anything like the Jap type adjustable ones. I think ya just mounted them around at whatever angle ya wanted them at. Going back a while now though.
Wondered how you'd mount an adjustable top on these towers. It'd take a little mod to top of strut tower. Wasn't sure if they were done in these.
Just running Monroe stuts in this
I adjusted rod bushes spacers after I bought the ute because at full lock it ha a tiny bit of rub on one of the inner guards and spaces front and rear of wheel weren't spot on. That was sorted back then. It's just the top of the strut in the tower that's in question now.
Bent z bar, control...