Search results

Hi all. My 2010 VE Omega V6 has a permanent P0016 and P0017 codes. I can wipe them, go for a drive and they reappear. Engine has 188k's. I took it to Heartland Holden and asked them if they'd change the Cam/Crank error tolerance before the ECM spits out the codes. I picked up the car and was...

Hi all, have a JG 2010 auto transmission has no reverse. It only tries to move very slightly (like someone rocking the car, revs to 3000rpm max, but doesn't move off). I'm taking it out myself to save some labour cost. I presume that it would be best to drop it from underneath onto the ground...

Thanks for the replies. Since some mentioned that it can be tight I decided to get stillsons spanner onto it. Finally unscrewed and it was jammed with white corrosion, so getting a new cap. When I drained it, there was only water, no coloured coolant. Will use the green coolant as the red one...

2009 VE Omega V6 sedan. Engine boiled and shut itself off (female driver). I drove out to it and put some water into the overflow reservoir very slowly until it flowed from its overflow hole. Am hearing gurgling sounds coming from the radiator but drove it home anyway; it didn't boil. 1. Looks...

Cut out all the loose edges and grind the edge to a slight bevel. Go to Bunnings and get as small a piece of metal flyscreen wire sheet that they will sell you. Wet the inside of the spoiler with some fibreglass 2 part mix, stick the matting inside of the spoiler while it is still wet and...

Hi all, I bogged up my rear quarter panel with some filler and primed it. Took it to the spray painters for a quote to spray metallic and clear and he said that they will IR it (infra red) to test the integrity of the filler under the primer. Is this done to all such repairs? I've never heard...

Thanks, I got a double set (5/16 & 3/8) on eBay for $23 incl postage from U.K., they have a reversable double ended cutter. Here was $45 for just one! Where can it be bought for $7.50 as suggested?

Hi all, I'm wondering what is the preferred method of removing spot welds. There are 2 types that I can see that can be used in normal drills. The cobalt flat bottom bit or one with an arbor mounted double-ended hole cutter. It's just for home use, obviously the flat bottom one is the cheapest...