So I've finally sold the Pulsar.
I need a new 307 lsd (or lower), reconditioned gearbox, and new suspension.
I've been looking on ebay and found plenty of struts that are labeled "suits FE2", I am not sure weather these are legit FE2's (or if FE2 only applies to the springs).
A reconditioned...
98 VT Spac V6 manual
Fitted a pair of Dynaudio woofers to my front doors and on the passenger side when I reassembled the door, I was a little forceful in putting the lock pin back in (top rear of the door to lock and unlock from the inside). It does not affect the opening, closing, locking and...
Checked with a multimeter. Where I mounted the Earth wire was only getting about 2 volts.
Remounted it to behind the plastic cover at the tail end of the boot. Powered up. Did some tricky **** with the low/high pass filters on the amp, bridged the channels, managed to get it very balanced. Front...
Upddate!
Replaced stock head unit with one from repco from automedia. Doubledin usb aux blutooth and preouts for sub and rears. Comes with harness. Installed. Doesnt quite fit properly, didnt have the mounting kit. New problem
Sub amp wont turn on
Checked amp in pulsar. Works.
Remote wire is...
Its not likely to be the original head unit considering the 2 codes in the book don't work... In theory there should only be about 1300 different combinations.... and I can try 3 times every hour..... So.... bruteforce method, going at it for 24 hours a day, I can knock it over in under 2 months...
Thanks for all your answers. We went to install the subs yesterday but it started raining half way through. When we removed the power to fit the main power cable running to the amp, it dropped the head unit into a security lock. I have 2 codes in my manual but neither of them work. It's less...
I mentioned I have everything else figured out. I have a converter, the necessary splitters, cables, tools etc. I just need to figure out which wire I can use as the remote on/off for the amp from the stock head unit.
I have read the wiring diagram, and I have a rough idea on which wire I could use as a remote wire.
I just want to make sure I have the right one that will turn on the amp with the head unit, and turn it off with the head unit or when the car turns off. Everything else I have figured out...