Recent content by Kim

Thanks

Hi all, I have searched the forum and found some info but I need some advice. My screen has developed a fault in my VF Evoke Wagon (2013). Advice in another post suggested: I have contacted a wrecker and they told me that the screen has to match my VIN. (See photo where the number is 9229...

Just did a steering wheel change on my VF Evoke wagon. Thanks so much for this post. It really made the job very easy. I found that the aluminium bolt in the centre of the wheel was fairly easy to remove for me. The whole job took about 20 minutes to remove the wheel and transfer over the...

Having just done the brakes on my 2014 Evoke VF Wagon on the weekend, the mounting bolts had a 19mm head and the 12mm for the slide pins. Note that this was for the stock PBR factory brakes, not the Brembo. Mounting bolts should be the same though.

So the facts: 1. Had trouble with electric cooling fan. If there is a cracked head or badly stuffed head gasket then the pressurised combustion gases will push into the water jacket and pump the water out of the radiator cap. Enough water goes missing and the thermostat that controls the fan...

Hi, Well after a bit of a break I am about to be back in a Commodore again *touch wood*. Bit of a step up getting a VE considering my last commodore was a VK... Anyway, I am looking to get proper log book servicing done on it but I want to keep the cost down. The vehicle will be under...

I got ill and had to sell out unfortunately. Long story. :)

I finally got an efi engine etc for the VK and now I need the high pressure fuel pump setup to push juice at it. Can anyone help me? Kim 0413 773 842 or email me. [email protected]

Grill Thanks for the offer mate but my grill is new. :)

Both engines are gone now

Yep, have been. Not much good around at the moment unfortunatley. K

I have two 3.3 (202) engines that I want out of my garage. 1. Black carby 3.3 Ran OK in my VK but had a big end rattle so it needs to be rebuilt. Is complete long motor. No dizzy. 2. Blue carby 3.3 Has head off for inspection. Bores seemed fine and the motor was rebuilt a few years back...

Hi all, Yesterday I picked up a 3.3 EFI motor and transmission (from VK) complete for $350 from a lovely chap who even trailered it over to my home for me! Engine was reco'd $30K ago and gear box is good so I just have to replace a few gaskets and clean her up and she will be in the car...

Done Bought one yesterday.

Hi, I am looking for a good motor for my VK. Good meaning one that has been reco'd within the last year or two. Ideally I would like a black with efi setup but a blue carby one would do. Also need a recently reco'd trimatic. I would prefer one in brisbane/goldcoast area if possible. Have the...