Recent content by CookedVy

Hey guys, a little while ago I put a l67 into my vy Ute. All is going well but it seems to have a lump on idle like theres a vacuum leak somewhere. I noticed under the throttle body there was a vacuum hose that was open. So I blocked it up with a screw and the idle went smooth. But when I went...

Also running a brand new 14 in 1 digital gauge, shows a solid 13psi at 4th gear

Yeah right, also forgot to mention it has 20thou pistons 82 degree thermostat, ported heads and charger. I know I won’t make the full 22psi but 13 seems a little low. I was told I would only probably make 16-18psi so 3-5psi is missing somewhere. I’ll check the boost bypass and see if it’s...

Hey guys, I’ve just recently put a l67 In my vy Ute. It’s got a 20psi pulley with 5% overdrive and a2a intercooler kit. Had it on the dyno a couple times to get it running nicely but can’t seem to get it to push more then 13psi. Done smoke test throughout the whole system which it passed with no...

Hey guys I’ve just recently put a l67 in my vy Ute. Runs amazing and couldn’t be happier. It’s running 20psi pulley with 5% overdrive and a a2a intercooler. I was wondering if it would be possible to put a bov in it. Was thinking putting it just before where it gets fed into the motor. Has...

Just don’t want to spend another $200 on o2 sensors as there are only a week old aha. But if it comes to it I think I’m gonna have to

Not sure what what one it was but it was off a mechanic worth around 5k, didn’t matter if the car was cold or warm, even after taking it for a quick blocky it still came up with o2 codes for left and right

Ahh right ahaha, would you know the reason for the o2 sensors not working? They are getting a mV reading but say “Not Ready” for LH and RH on scan tool

Kinda understand what your mean, but what do you mean by LIM IIRC?

Around the same area where the ecotec one sits maybe a little higher

Auto, yes, I’ve had it on the dyno just to get it to a point of where I can drive it to and from places as it’s got a bit of work done to the motor. The dyno place said they tried to tune it out but had no luck Motors had done A2A intercooler 20 thou pistons 20psi pulley Ported heads...

Hello everyone, I’ve recently just put a l67 in my vy Ute. Got it to start run and drive, However, when I give it a little throttle in neutral or park it hits a dead spot and unless I pump the gas pedal it will stall out on me. Also when I’m driving and come to a stop it will stall out on me...

I checked them and they are the same

no I haven’t checked them, are they different?

So I just recently swapped a vx l67 with some work done to it into my vy Ute. I’m running a vy loom into a vx ecu. When I go to start it it tries to start coughs and splutters but then dies out. I tried with a little throttle and wanted to go but once again coughing spluttering but blowing black...