Recent content by blownrat350

sorry just saw this.... Yer Nice the Kaaz seems to be the premium choice, you happy with it?

Nice, its def the preference if you've got the resources to set it up. Did you run the stock center ?

Yer sweet. They'd def be the bullet proof option. Did you do the dirty work yourself or have it done? It was partly the fact it was another added variable to nut out to. Not impossible to do, but it was easy to buy the kit and have it somewhat PnP. Still, it was interesting the new gear set sat...

Hey mate I've literately just finished the final pinion install with the same crush spacer type replacement that came with the new bearing kit. I considered the solid spacer setup but the old diff still had a tad under 9 inch pounds of pinion preload, and with 200 000Kms and a seriously hard...

sounds like it'll be a bloody good read mate, looking forward to it. At the risk of making this thread sound like an ad.............. Again!! haha. Ur not doin signed copies are you? Cheers for da laugh!!

old mate doesnt drive a SWB Nissan now by any chance?

Yer mate, its a custom job, from the chuck straight threw to the yoke........ I like to run a bigger cam in the flux-capacitor as well, for a little bit extra mid range spool. The secrete is a two piece cam!!!!

Thanks for the info everyone...... Haha. I got some spec's and thought Id throw them up, incase any one is gunna go it alone!!! Pinion preload is 14-19 inch-pounds Carrier Bearing preload measured at pinion = 10-15 inch-pounds (Multiplied by diff ratio + your pinion preload inch-pounds achieved...

Hey do you have any photos of this fitted? I cant get the other side of the bike rim on the rubber diff yoke. Thanks in advance Dan :cool:

my apologies bloke.... bloody new members!!!!

Hey, I was wondering if anyone has specs for the ZF diff, that the VE and VF's uses? There are some numbers on the internet, but there isn't a heap of helpful info, no doubt due to the short-lived usage in holdens, and even scarcer use in the USA gm cousins I'm replacing the internals in a...