Recent content by BigMat

Actually I found my one up above the footwell behind the dash panels and yes you have to unplug a lot of wiring, and brackets I even unclipped the brake lever so I could get a better look at what I was doing. But with this car it doesn’t surprise me how difficult Holden seems to make repair and...

Do you have a picture of the TCM in the 4l60e VE Commodore Omega 3.6 v6 my vechicle is exactly like that pic of the OP, but is it actually behind those white wiring connectors or higher up on the A pillar? Thanks

Sorry for hijacking your post but whereabouts is the TCM on a 2008 VE Commodore Omega with a 4l60e transmission on a 3.6 alloytech

I dropped the transmission pan today to check the Ohms resistance of the solenoids, It appears that 4 of them are outside recommended limits. The 3-2 shift solenoid reads 16.1 Ohms, The others where even lower values the TCC PWM reads 9.1 Ohms and the 1-2 and 2-3 read 11.1 Ohms. each while...

I dropped the transmission cross member to try gain access to the Electronic plug into the upper part of the transmission, Which didn't work anyway and only dropped it about two inches until it just stopped dropping, I put this down to the driveshaft still in the car but potentially it could...

Thanks BlackVXGTS its good to know and understand what you are saying. Is there a way to find the original as an online resource by subscribing to it? Do you know the url for the publisher or how I may subscribe. Thanks again Mat.

Thanks BlackVXGTS for the repair manual. Its quite detailed but sadly none of the links (urls) work in the document either but I assume it is complete. But the URLs refer to the other sections are akk broken, unless you go through them one at a time (all 10,000+ pages) and search for the...

Thanks BlackVXGTS I have corrected my dyslexic brain and iPhone finger . You are correct it is the P0787 DTC so thanks for the error in my ways. Do you by chance have the referred to Link that points to somewhere outside of that document that is titled: Control and Shift Solenoids...

I have a VE Omega 2008 3.6 Alloytech and. The M30 4L60e transmission that is only showing one error code. P0787 But I would like to know which specific Solenoid this error is referring to, as it doesn’t report if it is the 1/2 or the 3/4 or some other solenoid